Engineering, 23.04.2021 14:00 alupton4887
From the figure shown, find the allowable value of the force acting on the aluminum so that the maximum overall deformation of 2 mm or the stress in the materials will not be exceeded. Allowable stresses are; σ of bronze=120 MN/m^2 , σ of steel=140 MN/m^2 and σ of aluminum=80 MN/m^2 .
Answers: 2
Another question on Engineering
Engineering, 03.07.2019 15:10
If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.
Answers: 1
Engineering, 04.07.2019 18:10
Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.
Answers: 2
Engineering, 04.07.2019 18:10
Give heat transfer applications for the following, (i) gas turbines (propulsion) ) gas turbines (power generation). (iii) steam turbines. (iv) combined heat and power (chp). (v) automotive engines
Answers: 1
Engineering, 04.07.2019 18:10
Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux
Answers: 3
You know the right answer?
From the figure shown, find the allowable value of the force acting on the aluminum so that the maxi...
Questions
Mathematics, 12.09.2019 03:10
Physics, 12.09.2019 03:10
History, 12.09.2019 03:10
Mathematics, 12.09.2019 03:10
Mathematics, 12.09.2019 03:10
Computers and Technology, 12.09.2019 03:10
