subject
Engineering, 15.04.2021 19:50 Emiann222

If a 2:1 transformer has a 220 VAC input, a voltage test at the primary winding should produce a meter reading of A. 220 VAC.
B. 110 VAC
C. 440 VAC
D. 0 VAC.

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
question
Engineering, 04.07.2019 18:10
Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux
Answers: 3
question
Engineering, 04.07.2019 18:20
Air is compressed isentropically from an initial state of 300 k and 101 kpa to a final temperature of 1000 k. determine the final pressure using the following approaches: (a) approximate analysis (using properties at the average temperature) (b) exact analysis
Answers: 1
question
Engineering, 04.07.2019 18:20
Wiy doeres rere okhn a pump whon working betwon the same pressure range?
Answers: 2
You know the right answer?
If a 2:1 transformer has a 220 VAC input, a voltage test at the primary winding should produce a met...
Questions
question
Chemistry, 09.04.2021 05:10
question
Mathematics, 09.04.2021 05:10
question
Mathematics, 09.04.2021 05:10
question
Mathematics, 09.04.2021 05:10
question
Mathematics, 09.04.2021 05:10
Questions on the website: 13722361