Engineering, 14.04.2021 23:00 dhruvi62

Layna and Aaron have made an electromagnet by coiling a copper wire around an iron nail, then connecting the wire to a battery, as seen in Figure 1. This causes electricity to flow through the coil, magnetizing the nail and creating a magnetic field. Electromagnet diagram. A coil of wire is wrapped around an iron nail and connected to a battery.

QUESTION: Layna says that they can increase the strength of their electromagnet by wrapping more coils of wire around the iron nail. Aaron says that they can increase the strength of the electromagnet by connecting a different battery to the wire.

Who do you agree with? Use evidence from science class to explain your answer.

True or false - The only way to charge an object with static electricity is by rubbing it against another object.

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Draw the engineering stress-strain curve for (a) bcc; (b) fcc metals and mark important points.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Which of the following controllers anticipates the future from the slope of errors over time? a)-proportional b)-on/off c)-integral d)-derivative.

Answers: 2

Answer

You know the right answer?

Layna and Aaron have made an electromagnet by coiling a copper wire around an iron nail, then connec...