Engineering, 13.04.2021 20:10 vkyles84

Design a parallel resonant circuit for an AM radio receiver. The inductance can vary to adjust the resonant frequency in order to cover the full AM broadcast band, which is from 530 to 1610 kHz. The circuit bandwidth must be at least 20 kHz in order to reproduce the full station signal, but not too much more than that in order to filter out adjacent stations. The resistor value is 33 kΩ. The inductance varies with a fixed inductor Lfixed in series with a variable inductor that has a range from zero to Lvar in order to cover the broadcast band. Using standard 20% tolerance commercial values, obtain the value of the capacitor and the two inductors. Finally, determine the quality factor range of the circuit from the low end to the high end of the broadcast band. Given: w = 2pif, w0 = 1/sqrt(LC), B = w0/Q, Q = w0RC

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

Line joining liquid phase with liquid and solid phase mixture is known as: a) liquidus b) solidus c) tie line d) none of the mentioned

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

True or false (explain) (110)[111] is a slip system in bcc metals . the {111} family in fcc contains 8 planes. resolved shear stress (rss) in single crystals is just related to the applied stress. critical resolved shear stress (crss) in single crystal metals is direct proportional to the number of defects in the structure

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Awall of 0.5m thickness is to be constructed from a material which has average thermal conductivity of 1.4 w/mk. the wall is to be insulated with a material having an average thermal conductivity of 0.35 w/mk so that heat loss per square meter shall not exceed 1450 w. assume inner wall surface temperature of 1200°c and outer surface temperature of the insulation to be 15°c. calculate the thickness of insulation required.

Answers: 3

Answer

You know the right answer?

Design a parallel resonant circuit for an AM radio receiver. The inductance can vary to adjust the r...

Questions