Engineering, 08.04.2021 20:00 liluv8262

imagine a pipe that splits into a Y where each upper branch of the Y is at a 45 degree angle from the main stem. The inflow is through the main stem base of the Y, where the pipe is0.3 m diameter and has an upstream pressure of 380 kPa. One of the branches of the Y is a 0.1m diameter pipe where the flow exits to atmospheric pressure. The other branch of the Y is a 0.2m diameter pipe where the flow goes into other piping at a pressure of 200 kPa. Determine the candy reaction forces. You may assume the flow is steady state and neglect shear stress and weight.

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Consider a large isothermal enclosure that is maintained at a uniform temperature of 2000 k. calculate the emissive power of the radiation that emerges from a small aperture on the enclosure surface. what is the wavelength ? , below which 10% of the emission is concentrated? what is the wavelength ? 2 above which 10% of the emission is concentrated? determine the wavelength at which maximum spectral emissive power occurs. what is the irradiation incident on a small object placed inside the enclosure?

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Machinery that is a key part of the process and without which the plant or process cannot function is classifed as: (clo4) a)-critical machinery b)-essential machinery c)-general purpose machinery d)-none of the specified options.

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Most leaks in reciprocating air compressors can be detected and minimized by: (clo4) a)-detecting leakage areas using ultrasonic acoustic detector. b)-tightening joints and connections c)-replacing faulty equipment d)-all of the given options

Answers: 2

Answer

You know the right answer?

imagine a pipe that splits into a Y where each upper branch of the Y is at a 45 degree angle from th...

Questions

Engineering, 28.09.2020 05:01

A(n) is obtained by mixing slightly more acetylene than oxygen. a. neutral flame c. brazing flame b. oxidizing flame d. carburizing...