subject
Engineering, 08.04.2021 15:40 dchannakhone84

A standard seeded BOD5 test was conducted in a laboratory. It was revealed that the initial DO concentration in a BOD bottle which had been filled with 8 mL of wastewater sample and 292 mL of seeded dilution water was 8.9 mg/L just after preparation. After an incubation period of five days, the final DO concentration was reported as 1.4 mg/L. Meanwhile, DO concentration in the control bottle with seeded dilution water decreased from 9.0 to 8.8 mg/L within five days. a) What is the 5-day BOD of the wastewater sample? b) What would be the 5-day BOD of the wastewater sample if the technician tested the wastewater with the same dilution, this time without seeding, and found out that the DO changed from 8.9 to 1.4 mg/L again? c) Considering both results obtained in (a) and (b), what kind of wastewater do you think the sample belongs to? Discuss your answer. (Hint: Make sure to keep the P and f as ratios (without rounding off) until the end of the calculation.)

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.
Answers: 2
question
Engineering, 04.07.2019 18:20
Find the kinematic pressure of 160kpa. for air, r-287 j/ kg k. and hair al viscosity of air at a temperature of 50°c and an absolute (10 points) (b) find the dynamic viscosity of air at 110 °c. sutherland constant for air is 111k
Answers: 3
question
Engineering, 04.07.2019 19:10
Aplate of dimensions 3 m x 3 m is placed 0.37 mm apart from a fixed plate. the plate requires a force of 2n to move at speed of 45 cm/s. evaluate the viscosity of the fluid in between the plates
Answers: 3
question
Engineering, 04.07.2019 19:10
Ahelical coil spring has a mean diameter of 50 mm, a wire diameter of 5.5 mm and is wound with a pitch of 10 mm. the spring steel has an ultimate strength of 1250 mpa. find the force needed to compress the spring solid and the wire stress in this condition. state whether the spring will return to its initial length.
Answers: 1
You know the right answer?
A standard seeded BOD5 test was conducted in a laboratory. It was revealed that the initial DO conce...
Questions
question
Computers and Technology, 19.07.2019 14:30
question
Mathematics, 19.07.2019 14:30
question
History, 19.07.2019 14:30
Questions on the website: 13722367