Engineering, 06.04.2021 05:20 queenskyyt
10 pts) A wastewater is to be treated in a typical completely mixed activated-sludge system to a effluent BOD of 5 mg/L. The average flow rate is 18,300 m3/d. The influent BOD is 160 mg/L. The system is to operate at a concentration of 4,000 mg/L MLSS and 15 d mean cell residence time. The secondary clarifier is designed to thicken the sludge to 12,000 mg/L. Assume a yield coefficient of 0.5, an endogenous decay rate (kd) of 0.04 d-1 and the solids concentration in the effluent can be ignored. Design the secondary treatment system by determining: a) The volume of the aeration tank b) The flow rate of the WAS c) The flow rate of the RAS d) The sludge recycle ratio (RAS%) e) The mass of sludge wasted each day (in kg/day) f) Check the F:M
Answers: 1
Another question on Engineering
Engineering, 03.07.2019 14:10
When at a point two solid phase changes to one solid phase on cooling then it is known as a) eutectoid point b) eutectic point c) peritectic point d) peritectoid point
Answers: 3
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
Engineering, 04.07.2019 18:20
Most leaks in reciprocating air compressors can be detected and minimized by: (clo4) a)-detecting leakage areas using ultrasonic acoustic detector. b)-tightening joints and connections c)-replacing faulty equipment d)-all of the given options
Answers: 2
Engineering, 04.07.2019 19:20
Apiping systems consists of 6 m of 6-std type k and 12 m of 4-std type k, both drawn copper tubing. the system conveys ethylene glycol at a rate of 0.013 m3/s. the pressure drop across the system is to be calculated. there are two 90° elbows in the 6-in pipe, a reduction from the 6-in pipe to the 4-in pipe and four 90° elbows in the 4-in pipe. all fittings are soldered (same as flanged) and regular. the inlet and outlet of the system are at the same height.
Answers: 1
You know the right answer?
10 pts) A wastewater is to be treated in a typical completely mixed activated-sludge system to a eff...
Questions
Computers and Technology, 16.11.2019 06:31
Social Studies, 16.11.2019 06:31
Arts, 16.11.2019 06:31
Mathematics, 16.11.2019 06:31
