Engineering, 06.04.2021 05:00 cherokeesiouxw72

The surface of a 2-ha catchment is characterized by a runoff coefficient of 0.5, a Manning n for overland flow of 0.25, an average overland flow length of 60 m, and an average slope of 0.5%. The time of concentration can be calculated by the kinematic-wave equation. The drainage channel is to be sized for the peak runoff resulting from a 10-year rainfall event, and the 10-year IDF curve is given by i=150/(t+8.96)^.78

where i is the average rainfall intensity in cm/h and t is the duration in minutes. The minimum time of concentration is 5 minutes. Determine the peak runoff rate.

Answers: 2

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Machinery that is a key part of the process and without which the plant or process cannot function is classifed as: (clo4) a)-critical machinery b)-essential machinery c)-general purpose machinery d)-none of the specified options.

Answers: 1

Answer

You know the right answer?

The surface of a 2-ha catchment is characterized by a runoff coefficient of 0.5, a Manning n for ove...

Questions