Engineering, 06.04.2021 03:00 Mattixwillard

5. The pin support at A allows . Select the one that applies. (a) displacement in the x direction (b) rotation about its central axis (c) displacement in the y direction (d) none of the above 6. The support at B does not allow . Select the one that applies. (a) displacement in the x direction (b) rotation about its central axis (c) displacement in the y direction

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

Explain the difference laminar and turbulent flow. explain it with the shear stress and the velocity profiles.

Answers: 1

Answer

Engineering, 03.07.2019 23:20

Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2

Answers: 3

Answer

You know the right answer?

5. The pin support at A allows . Select the one that applies. (a) displacement in the x direction (b...

Questions

Engineering, 29.09.2019 01:10

Find the stress (psi) in a rod with a 0.80 in diameter caused by a 523 lb axial load....

Engineering, 29.09.2019 01:10

Give two crystal structures that are considered closed-packed structures....

Engineering, 29.09.2019 01:10

Two elements, aluminum (al) and chrome (cr) are being considered for use in making solid solution alloy with gold (au). which element will be the bett...

Engineering, 29.09.2019 01:10