Engineering, 06.04.2021 01:50 princess6039
Two previously undeformed specimens of the same metal are to be plastically deformed by reducing their cross-sectional areas. One has a circular cross section, and the other is rectangular; during deformation, the circular cross section is to remain circular, and the rectangular is to remain rectangular. Their original and deformed dimensions are as follows:
Circular Rectangular
(diameter, mm)
Original dimension 18.0 20×50
Deformed dimension 15.9 13.7×55.1
Which of these specimens will be the hardest after plastic deformation, and why?
Answers: 3
Engineering, 03.07.2019 23:20
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
Engineering, 04.07.2019 18:10
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
Engineering, 04.07.2019 18:10
Thermal stresses are developed in a metal when its a) initial temperature is changed b) final temperature is changed c) density is changed d) thermal deformation is prevented e) expansion is prevented f) contraction is prevented
Answers: 2
Engineering, 04.07.2019 18:10
Machinery that is a key part of the process and without which the plant or process cannot function is classifed as: (clo4) a)-critical machinery b)-essential machinery c)-general purpose machinery d)-none of the specified options.
Answers: 1
Two previously undeformed specimens of the same metal are to be plastically deformed by reducing the...
English, 28.08.2019 04:00
Physics, 28.08.2019 04:00
Social Studies, 28.08.2019 04:00
Mathematics, 28.08.2019 04:00
Physics, 28.08.2019 04:00
History, 28.08.2019 04:00
Social Studies, 28.08.2019 04:00
Mathematics, 28.08.2019 04:00
Mathematics, 28.08.2019 04:00