Engineering, 06.04.2021 01:00 shawny5

In an afterburning jet engine during a static test, the fluid entering the after- burner has a temperature of 900 K, a pressure of 0.235 MPa and a mass flow rate of 75 kg/s. These conditions are maintained with and without operation of the afterburner. Without afterburning, the stagnation pressure loss be- tween afterburner entrance and exit is 3 percent and the specific heat ratio of the fluid in the nozzle is 1.33. When the afterburner is operating, the exit stagnation temperature rises to 1800 K, the stagnation pressure loss changes to 8 percent and the specific heat ratio in the nozzle drops to 1.29. In both cases the nozzle flow is simply converging and choked. Determine the re- quired nozzle exit area in both cases.

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

If the thermal strain developed in polyimide film during deposition is given as 0.0044. assume room temperature is kept at 17.3 c, and thermal coefficient of expansion for the film and the substrate are 54 x 10^-6c^-1 and 3.3 x 10^-6c^-1respectively. calculate the deposition temperature.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Inadequate stores control is not an obstacle to effective work order system. (clo4) a)-true b)-false

Answers: 3

Answer

Engineering, 04.07.2019 19:10

Air inially occupying a volume of 1 m2 at 100 kpa, 27 c undergoes three internally reversible processes in series. process 1-2 compression to 500 kpa during which pv constant process 2-3 adiabatic expanslon to 100 kpa process 3-1: constant-pressure expansion to 100 kpa (a) calculate the change of entropy for each of the three processes. (b) calculate the heat and work involved in each process. (c) is this cycle a power cycle or refrigeration cycle?

Answers: 3

Answer

You know the right answer?

In an afterburning jet engine during a static test, the fluid entering the after- burner has a tempe...

Questions