1. What's the maximum overall length of the part?
2. What material is used to fabricate the pa...
Engineering, 30.03.2021 16:20 ciel8809
1. What's the maximum overall length of the part?
2. What material is used to fabricate the part
Answers: 2
Another question on Engineering
Engineering, 04.07.2019 18:10
Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.
Answers: 1
Engineering, 04.07.2019 18:10
Which of the following refers to refers to how well the control system responds to sudden changes in the system. a)-transient regulation b)- distributed regulation c)-constant regulation d)-steady-state regulation
Answers: 1
Engineering, 04.07.2019 18:10
Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?
Answers: 3
Engineering, 04.07.2019 18:20
Asimple rankine cycle uses water as the working fluid. the water enters the turbine at 10 mpa and 480c while the condenser operates at 6 kpa. if the turbine has an isentropic efficiency of 80 percent while the pump has an isentropic efficiency of 70 percent determine the thermal efficiency
Answers: 1
You know the right answer?
Questions
Biology, 04.03.2020 01:26
Biology, 04.03.2020 01:26
Mathematics, 04.03.2020 01:27
Mathematics, 04.03.2020 01:27
Mathematics, 04.03.2020 01:27
Mathematics, 04.03.2020 01:27
Computers and Technology, 04.03.2020 01:27
Mathematics, 04.03.2020 01:27
