subject
Engineering, 29.03.2021 19:30 Maaaryyss

A workpiece in the form of a bar 100 mm in diameter is to be turned down to 70 mm diameter for 50 mm of its length. A roughing cut using maximum power and a depth of cut of 12 mm is to be followed by a finishing cut using a feed of 0.1 mm and a cutting speed of 1.5 m/s. It takes 20 s to load and unload the workpiece and 30 s to set the cutting conditions, set the tool at the beginning of the cut and engage the feed. The specific cutting energy for the material is 2.3 GJ/m3 and the lathe has a 3-kW motor and a 70 percent efficiency. Estimate:

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
question
Engineering, 04.07.2019 18:10
Journeyman training is usually related (clo2) a)-to specific tasks b)-to cost analysis of maintenance task c)-to control process to ensure quality d)-to installation of machinery
Answers: 2
question
Engineering, 04.07.2019 18:20
Athin walled concentric tube exchanger is used to cool engine oil from 160°c to 60°c with water that is available at 25°c acting as a coolant. the oil and water flow rates are each at 2 kg/s, and the diameter of the inner tube is 0.5 m and the corresponding value of the overall heat transfer coefficient is 250 w/m2. oc. how long must the heat exchanger be to accomplish the desired cooling? cpwater=4.187 kj/kg-candcpengine el=2.035 kj/kg·°c, oil . 120]
Answers: 1
question
Engineering, 04.07.2019 19:10
The air in an automobile tire with a volume of 0.015 m3 is at 32°c and 140 kpa gage. determine the amount of air that must be added to raise the pressure to the recommended value of 206 kpa gage. assume the atmospheric pressure to be 128 kpa and the temperature and the volume to remain constant.[r-0.287 kj/kgk]
Answers: 3
You know the right answer?
A workpiece in the form of a bar 100 mm in diameter is to be turned down to 70 mm diameter for 50 mm...
Questions
question
Mathematics, 06.06.2020 05:04
question
Mathematics, 06.06.2020 05:04
Questions on the website: 13722363