Engineering, 22.03.2021 20:30 kaleahearly123

UNIT THREE ASSIGNMENT 1. An a. c. bridge is arranged as follows: The arms AB and BC consist of non-inductive
resistance of 100 S2, the arms BE and CD of non-inductive variable resistances, the arm
EC of a capacitor of 1 uF capacitance, the arm DA of an inductive resistance. The a. c.
source is connected to A and C and the telephone receiver to E and D. A balance is
obtained when the resistances of the arms CD and BE are 50 12 and 2500 12 respectively.
Calculate the resistance and the inductance of the arm DA. What would be the effect of
harmonics in the waveform of the alternating current source?

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Give heat transfer applications for the following, (i) gas turbines (propulsion) ) gas turbines (power generation). (iii) steam turbines. (iv) combined heat and power (chp). (v) automotive engines

Answers: 1

Answer

Engineering, 04.07.2019 19:10

Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.

Answers: 2

Answer

Engineering, 04.07.2019 19:10

Ahelical coil spring has a mean diameter of 50 mm, a wire diameter of 5.5 mm and is wound with a pitch of 10 mm. the spring steel has an ultimate strength of 1250 mpa. find the force needed to compress the spring solid and the wire stress in this condition. state whether the spring will return to its initial length.

Answers: 1

Answer

Engineering, 04.07.2019 19:20

Determine (a) the maximum thermal efficiency of reversible power cycles operating between a hot reservoir at 1000°c and a cold reservoir at 200°c and (b) the maximum cops for reversible refrigeration and heat pump cycies, respectively, between 28°c and 14°c.

Answers: 1

Answer

You know the right answer?

UNIT THREE ASSIGNMENT 1. An a. c. bridge is arranged as follows: The arms AB and BC consist of non-...

Questions