subject
Engineering, 22.03.2021 09:40 zoedaejohnson

Part of the gear train for a Lath machine tool is shown. Compound gears 2 and 3 slide on a splined shaft so that gear 3 can mesh with gear 4 or gear 2 can mesh with gear 6. Also, compound gears 14 and 15 slide on a splined shaft so that gear 14 can mesh with gear 16 or gear 15 can mesh with gear 17. the angular velocity ratio for the transmission is given by:

Where ωo = ω16 = ω17 and ωi = ω2 = ω3

a/ What should be the two possibility of y. (2 Marks).
b/ What should be the two possibility of x. (2 Marks).
c/ If gear 3 meshes with gear 4, calculate the two possible spindle speeds for a motor speed of 1800 rpm?
(3 Marks).
d/ Now assume that gear 14 meshes with gear 16, and gear 2 meshes with gear 6.
Calculate the number of tooth N6 of gear 6 if N2=10 tooth and ωo=130 rpm? (3 Marks).


Part of the gear train for a Lath machine tool is shown. Compound gears 2 and 3 slide on a splined

ansver
Answers: 2

Another question on Engineering

question
Engineering, 03.07.2019 15:10
Apiston-cylinder with a volume of 0.25 m3 holds 1 kg of air (r 0.287 k/kgk) at a temperature of 100 c. heat transfer to the cylinder causes an isothermal expansion of the piston until the volume triples. how much heat is added to the piston-cylinder?
Answers: 3
question
Engineering, 04.07.2019 18:10
Steel is coated with a thin layer of ceramic to protect against corrosion. what do you expect to happen to the coating when the temperature of the steel is increased significantly? explain.
Answers: 1
question
Engineering, 04.07.2019 18:10
Which of the following refers to refers to how well the control system responds to sudden changes in the system. a)-transient regulation b)- distributed regulation c)-constant regulation d)-steady-state regulation
Answers: 1
question
Engineering, 04.07.2019 18:20
Most leaks in reciprocating air compressors can be detected and minimized by: (clo4) a)-detecting leakage areas using ultrasonic acoustic detector. b)-tightening joints and connections c)-replacing faulty equipment d)-all of the given options
Answers: 2
You know the right answer?
Part of the gear train for a Lath machine tool is shown. Compound gears 2 and 3 slide on a splined s...
Questions
question
Spanish, 01.03.2021 01:00
question
Business, 01.03.2021 01:00
question
Mathematics, 01.03.2021 01:00
question
Arts, 01.03.2021 01:00
question
Chemistry, 01.03.2021 01:00
Questions on the website: 13722367