Engineering, 21.03.2021 23:50 iiisavageoreo

Q2: Use navigation sensors to track an AUV with acoustic transceivers and DVL Q2.1. We have two acoustic hydrophones to detect the sound transmitted from the AUV. As shown in the figure below, the range to the AUV measured by the #1 hydrophone is 200m and by #2 hydrophone is 215m, and the baseline, b, is 20 meters. What is the vertical and horizontal distance between the AUV and hydrophone #1? [10pts]. The equation that will be used is in Topic-4 presentation. (show full calculation steps)

Q2.2. The AUV is equipped with a DVL that transmits sound at 1MHz. The beam angle is 22.5 degrees. The AUV is moving at a speed, u, of 2 m/s. As presented in the lecture, we can separate it into two components, one along the sound transmission of #1 beam on the DVL, one is perpendicular to the sound transmission. Question: now let’s separate u relative to beam #2, draw the two components in the figure and compute the magnitude of the two components. [5pts]

Answers: 2

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

Amass of m 1.5 kg of steam is contained in a closed rigid container. initially the pressure and temperature of the steam are: p 1.5 mpa and t 240°c (superheated state), respectively. then the temperature drops to t2= 100°c as the result of heat transfer to the surroundings. determine: a) quality of the steam at the end of the process, b) heat transfer with the surroundings. for: p1.5 mpa and t 240°c: enthalpy of superheated vapour is 2900 kj/kg, specific volume of superheated vapour is 0. 1483 m/kg, while for t 100°c: enthalpy of saturated liquid water is 419kj/kg, specific volume of saturated liquid water is 0.001043m/kg, enthalpy of saturated vapour is 2676 kj/kg, specific volume of saturated vapour is 1.672 m/kg and pressure is 0.1 mpa.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Draw the engineering stress-strain curve for (a) bcc; (b) fcc metals and mark important points.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

You are making beer. the first step is filling the glass carboy with the liquid wort. the internal diameter of the carboy is 15 in., and you wish to fill it up to a depth of 2 ft. if your wort is drawn from the kettle using a siphon process that flows at 3 gpm, how long will it take to fill?

Answers: 1

Answer

Engineering, 04.07.2019 18:20

For each of the following process: a) sketch the p-v diagram, b)sketch t-s diagram, c) sketch t-v diagram, d) sketch the boundary work on one of the diagrams (a, b or c) and e) sketch the reversible heat transfer on one of the diagrams (a, b or c): 1- isobaric process from compressed liquid to superheated vapor 2- isothermal process from compressed liquid to superheated vapor 3- isentropic process from compressed liquid to superheated vapor

Answers: 3

Answer

You know the right answer?

Q2: Use navigation sensors to track an AUV with acoustic transceivers and DVL Q2.1. We have two aco...

Questions