Exam Lesson Name: The Trades of Plumbing and Pipefitting
Exam number: 286115RR
Exam Guideline...
Engineering, 21.03.2021 03:40 aileenf598
Exam Lesson Name: The Trades of Plumbing and Pipefitting
Exam number: 286115RR
Exam Guidelines
Exam Instructions
Question 7 of 20
Select the best answer for the question
7. Which one of the following was once considered state-of-the art and is still used for control systems and instrumentation in buildings?
A. Steam
B. Brine
C. Compressed air
D. Deionized water
Answers: 2
Engineering, 03.07.2019 23:20
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
Engineering, 04.07.2019 18:10
During a steady flow process, the change of energy with respect to time is zero. a)- true b)- false
Answers: 2
Engineering, 04.07.2019 18:10
Give heat transfer applications for the following, (i) gas turbines (propulsion) ) gas turbines (power generation). (iii) steam turbines. (iv) combined heat and power (chp). (v) automotive engines
Answers: 1
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
Mathematics, 17.10.2021 07:30
Mathematics, 17.10.2021 07:30
Mathematics, 17.10.2021 07:30
Arts, 17.10.2021 07:30
Mathematics, 17.10.2021 07:30
Mathematics, 17.10.2021 07:30
Mathematics, 17.10.2021 07:30
Mathematics, 17.10.2021 07:30
Advanced Placement (AP), 17.10.2021 07:30
Mathematics, 17.10.2021 07:30
History, 17.10.2021 07:30