subject
Engineering, 18.03.2021 01:20 ambercuevas2707

A proposed embankment fill requires 7100 ft of compacted soil. The void ratio of the compacted fill is specified as 0.5. Four borrow pits are available as below, which list the respective void ratios of the soil and the cost per cubic feet for moving the soil to the proposed construction site. Make the necessary calculations to determine the total cost for each pit. Assume the specific gravity of soil solids, Gs to be the same at all pits. 1. Calculate the volume of solid (Vs) = ft3 Borrow Pit A: void ratio = 1.05 and the unit cost = $ 6 /ft3
2. Calculate the total cost to pay to Pit A = Borrow Pit B: void ratio = 0.61 and the unit cost = $ 7 /ft3
3. Calculate the total cost to pay to Pit B = Borrow Pit C: void ratio = 0.81 and the unit cost = $ 4 /ft3
4. Calculate the total cost to pay to Pit C = Borrow Pit D: void ratio = 0.73 and the unit cost = $6 /ft3
5. Calculate the total cost to pay to Pit D =

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Fluids at rest possess no flow energy. a)- true b)- false
Answers: 3
question
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
question
Engineering, 04.07.2019 18:10
For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater
Answers: 3
question
Engineering, 04.07.2019 18:20
Derive the correction factor formula for conical nozzle i=-(1+ cosa) and calculate the nozzle angle correction factor for a nozzle whose divergence hal-fangle is 13 (hint: assume that all the mass flow originates at the apex of the cone.
Answers: 3
You know the right answer?
A proposed embankment fill requires 7100 ft of compacted soil. The void ratio of the compacted fill...
Questions
question
Arts, 05.06.2021 06:20
question
Chemistry, 05.06.2021 06:20
question
Arts, 05.06.2021 06:20
Questions on the website: 13722361