Engineering, 08.03.2021 22:40 scholar13

1) Draw a one-line schematic (by hand, PowerPoint, or other) and label components for a network consisting of: (10 pts). a) A 4160 VAC distribution feeder b) A 480 VAC main bus c) A transformer connecting the 4160 VAC distribution feeder to the 480 VAC main bus d) Isolation equipment (breaker) on each side of the transformer e) Solar PV generating power with range 300-700 VDC f) Solar PV inverter with input power in the range of 300-700 VDC to produce output power at 480 VAC, connected to the main bus g) A 480 VAC motor connected to the main bus h) A step-down transformer from 480 VAC to 120 VAC to power building electrical outlets i) Load for the building electrical outlets j) Battery with operating range 400-600 VDC k) Battery bi-directional inverter with operating range 400-600 VDC (DC side) and 480 VAC (AC side) connected to the main bus l) Stand-by generator with 480 VAC output connected directly to the main bus

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Different types of steels contain different elements that alter the characteristics of the steel. for each of the following elements, explain what the element does when alloyed with steel.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)

Answers: 3

Answer

Engineering, 04.07.2019 19:10

With increases in magnification, which of the following occur? a. the field of view decreases. b. the ambient illumination decreases. c. the larger parts can be measured. d. the eyepiece must be raised.

Answers: 1

Answer

You know the right answer?

1) Draw a one-line schematic (by hand, PowerPoint, or other) and label components for a network cons...

Questions