Engineering, 08.03.2021 07:10 shay03littletop5kx2p

Multiple Choice Which option explains how the engineer can adcomplish his or her task in the following scenario?
Highway 51 is expanding, so an engineer is hired to help move a small house to a new location. The
engineer uses special equipment to raise the house onto a flatbed truck.
A machine will be used where pressure applied to a fluid in a device will transfer pressure to all sides of
its container, enabling the machine to lift a large amount of weight
Power is provided to a machine via an engine that uses an electrical current.
Construction of a water tower will create the water pressure necessary to make the engineer's machine
work
Valves are placed around the home to regulate the direction the machine can move around the home

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Air is to be cooled in the evaporator section of a refrigerator by passing it over a bank of 0.8-cm-outer-diameter and 0.4-m-long tubes inside which the refrigerant is evaporating at -20°c. air approaches the tube bank in the normal direction at 0°c and 1 atm with a mean velocity of 4 m/s. the tubes are arranged in-line with longitudinal and transverse pitches of sl- st 1.5 cm. there are 30 rows in the flow direction with 15 tubes in each row. determine (a) the refrigeration capacity of this system and (b) pressure drop across the tube bank. evaluate the air properties at an assumed mean temperature of -5°c and 1 atm. is this a good assumption?

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

The higher the astm grain size number, the finer the gran is. a)-true b)-false

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i.d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.

Answers: 3

Answer

You know the right answer?

Multiple Choice Which option explains how the engineer can adcomplish his or her task in the follow...

Questions