Engineering, 25.02.2021 07:20 dkckdkcekkxgmaipcom

Which physical quantity measures the rate at which an object’s velocity changes? A.
force
B.
speed
C.
acceleration
D.
torque

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Which from the following instrument is commonly used to detect the high pitch butzing sound in bearings? [clo4] a)-digital ultrasonic meter b)-infrared camera c)-spectroscopic d)-vibrometer

Answers: 2

Answer

Engineering, 06.07.2019 04:10

Aspherical thermocouple measurement errors a spherical thermocouple made of constantin transfer coefficient between the gas and the thermocouple is h used to measure the temperature of a gas. the heat 400 w/m2 k. calculate the maximum diameter d of the thermocouple if the thermocouple's measurement error should be w 23 within 5% of the initial temperature difference in 5 seconds. for constantin, k 8920 kg/m3, and c 410 j/kg. k.

Answers: 3

Answer

Engineering, 06.07.2019 04:10

Water flows at the rate of 200 i/s upwards through a tapered vertical pipe. the diameter at marks(3) clo5) the bottom is 240 mm and at the top 200 mm and the length is 5m. the pressure at the bottom is 8 bar, and the pressure at the topside is 7.3 bar. determine the head loss through the pipe. express it as a function of exit velocity head.

Answers: 3

Answer

Engineering, 06.07.2019 04:10

An array of m-50 thermoelectric modules is installed on the exhaust of a sports car. each module has an effective seebeck coefficient of sp of 0.143 5vk and an internal electrical resistance of r.-4 ? in addition, : (15 points each module is of width w 60mm and contains n=100 pairs of semiconducting pellets. each pellet hasan overall length of 2l-5mm and a cross-sectional area as 1.2 x 10'm and is characterized by a thermal conductivity of kpl2w rnk. the hot side of each module is exposed to exhaust gases at·p650c with hia4ow rrk while the osite side of each module is cooled by pressurized water at surface) and 156 °c (at the cool surface). 11s c with h: -500w/m'k. the modules are wired n series and the load resistance is r d=400ohm .the module surface temperatures, t, and ts are 183 "c (at the hot surface and 156c (at the cool surface) a)-draw a schematic of this scenario and label all parts. a. b. if the induced current, i, is 0.15 amps, what is the total power (pa) for one module? c. what is the total power harvest from the exhaust with all 50 modules?

Answers: 2

Answer

You know the right answer?

Which physical quantity measures the rate at which an object’s velocity changes? A.
force<...

Questions