Engineering, 22.02.2021 22:10 Isactuallycarter99
A solid steel shaft is to be designed to transmit 750 kW at 1,500 revolutions per minute. The steel selected is an AISI 1030, cold drawn (CD) steel. The shaft is 1 m long. Assume that the bending load on the shaft is negligible. (a) Using a factor of safety of 1.5, design the diameter of the shaft. (b) If instead of using a solid shaft, a hollow shaft with the inside diameter 0.8 times the outside diameter is used, will there be any weight saving
Answers: 2
Another question on Engineering
Engineering, 03.07.2019 14:10
Line joining liquid phase with liquid and solid phase mixture is known as: a) liquidus b) solidus c) tie line d) none of the mentioned
Answers: 2
Engineering, 03.07.2019 15:10
Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.
Answers: 1
Engineering, 04.07.2019 03:10
What precautions should you take to prevent injuries when dealing with heavy loads?
Answers: 1
Engineering, 04.07.2019 18:20
Steam enters a converging nozzle at 3.0 mpa and 500°c with a at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: negligible velocity, and it exits (a) is isentropic (b) has an efficiency of 94 percent
Answers: 2
You know the right answer?
A solid steel shaft is to be designed to transmit 750 kW at 1,500 revolutions per minute. The steel...
Questions
Mathematics, 02.12.2019 05:31
Mathematics, 02.12.2019 05:31
History, 02.12.2019 05:31
Social Studies, 02.12.2019 05:31
English, 02.12.2019 05:31
Social Studies, 02.12.2019 05:31
Chemistry, 02.12.2019 05:31
Biology, 02.12.2019 05:31
Health, 02.12.2019 05:31
Mathematics, 02.12.2019 05:31
