subject
Engineering, 22.02.2021 19:40 Disd112984

Seawater containing 3.50 wt% salt passes through a series of 10 evaporators. Roughly equal quantities of water are vaporized in each of the 10 units and then condensed and combined to obtain a product stream of fresh water. The brine leaving each evaporator but the tenth is fed to the next evaporator. The brine leaving the tenth evaporator contains 5.00 wt% salt. (a) Draw a flowchart of the process showing the first, fourth, and tenth evaporators. Label all the streams entering and leaving these three evaporators.
(b) Write in order the set of equations you would solve to determine the fractional yield of fresh water from the process (kg H2O recovered/kg H2O in process feed) and the weight percent of salt in the solution leaving the fourth evaporator. Each equation you write should contain no more than one previously undetermined variable. In each equation, circle the variable for which you would solve. Do not do the calculations.
(c) Solve the equations derived in Part (b) for the two specified quantities.

ansver
Answers: 3

Another question on Engineering

question
Engineering, 03.07.2019 15:10
Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.
Answers: 1
question
Engineering, 06.07.2019 03:10
How to convert a friction to decimal ?
Answers: 1
question
Engineering, 06.07.2019 03:20
Aload of 10kn is to be suddenly applied to the free end of a vertical rod of length 500 mm, the upper end being rigidly fixed. 190 mechanical science what should the diameter of the rod be if the maximum stress in the rod is not to exceed 100 mpa? the tensile modulus of the rod is 205 gpa.
Answers: 2
question
Engineering, 06.07.2019 03:20
Not a characteristic property of ceramic material (a) high temperature stability (b) high mechanical strength (c) low elongation (d) low hardness
Answers: 2
You know the right answer?
Seawater containing 3.50 wt% salt passes through a series of 10 evaporators. Roughly equal quantitie...
Questions
question
Mathematics, 25.02.2021 14:00
Questions on the website: 13722363