subject
Engineering, 19.02.2021 23:00 sarahc63

A steel rod of length 1m is of diameter 75mm over a portion 0.7m long and of diameter 45mm over the remainder. Calculate the strain energy in the rod when it is subject to an axial tension 50KN . Youngs modulus =210KN per millimetre square

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2
Answers: 3
question
Engineering, 04.07.2019 18:20
Air is compressed isentropically from an initial state of 300 k and 101 kpa to a final temperature of 1000 k. determine the final pressure using the following approaches: (a) approximate analysis (using properties at the average temperature) (b) exact analysis
Answers: 1
question
Engineering, 04.07.2019 18:20
How much power could a wind turbine produce if it had the following specifications? cp = 0.45 -d=1.2kg/m3 d=50m v 5m/s
Answers: 2
question
Engineering, 04.07.2019 19:10
Estimate the change in specific internal energy au and specific enthalpy h from inlet to outlet for ethylene glycol (a liquid) flowing through each of the following devices: (a) a heat exchanger where the glycol temperature increases from 20 °c to 80 °c; (b) a pump operating at about 25 °c and increasing the glycol pressure from 100 kpa to 8 mpa.
Answers: 2
You know the right answer?
A steel rod of length 1m is of diameter 75mm over a portion 0.7m long and of diameter 45mm over the...
Questions
question
Mathematics, 19.01.2021 21:00
question
Mathematics, 19.01.2021 21:00
question
Arts, 19.01.2021 21:00
question
Mathematics, 19.01.2021 21:00
Questions on the website: 13722361