Engineering, 19.02.2021 16:20 ethancarter560

Show truth tables for each of the following. a. There are four inputs and twooutputs. The inputs, w, x, y, z, are codes for the grade that may be received:

0000 A+ 0100 A 1000 A- 1100 Incomplete
0001 B+ 0101 B 1001 B- 1101 Satisfactory
0010 C+ 0110 C 1010 C- 1110 Unsatisfactory
0011 D+ 0111 E 1011 XE 1111Pass

The outputs are
1: a 1 if and only if the grade is C or better (only letter grades; Câ€”is not C or better)
2: a 1 if and only if the university will count it toward the 120 credits required for a degree (passing grade only)
3: a 1 if and only if it will be counted in computing a grade point average (letter grades only).

b. The system has four inputs and three outputs. The first two inputs, a and b, represent a 2-bit binary number (range of 0 to 3). A second binary number (same range) is represented by the other two inputs, c and d. The output f is to be 1 if and only if the two numbers differ by exactly 2. Output g is to be 1 if and only if the numbers are equal. Output h is to be 1 if and only of the second number is larger than the first.

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 12:10

On a average work day more than work place firs are reorted

Answers: 1

Answer

Engineering, 04.07.2019 16:10

An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)

Answers: 2

Answer

Engineering, 04.07.2019 18:10

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.

Answers: 1

Answer

You know the right answer?

Show truth tables for each of the following. a. There are four inputs and twooutputs. The inputs, w...

Questions