Engineering, 16.02.2021 17:30 natalie2sheffield

A company makes two kinds of leather belts A & B, Belt A is of high quality and belt B is of low quality. The respective profit are

Rs. 4 and Rs. 3 per belt. The production of each of type A belt

requires twice as much time as of belt of type B, and if all belts were

of B type, the company would make 1000 belts per day. The supply

of leather is sufficient for only 800 belts per day (for A & B type

combined). Belt A requires a fancy buckle and only 400 of these are

available per day. There are 700 buckles a day available for belt B.

What should be the daily production of each type of belt? Formulate

this problem as an LP model and solve it using the simplex method.

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 16:10

An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)

Answers: 2

Answer

Engineering, 04.07.2019 18:10

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

Answer

Engineering, 04.07.2019 18:10

You are making beer. the first step is filling the glass carboy with the liquid wort. the internal diameter of the carboy is 15 in., and you wish to fill it up to a depth of 2 ft. if your wort is drawn from the kettle using a siphon process that flows at 3 gpm, how long will it take to fill?

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Awall of 0.5m thickness is to be constructed from a material which has average thermal conductivity of 1.4 w/mk. the wall is to be insulated with a material having an average thermal conductivity of 0.35 w/mk so that heat loss per square meter shall not exceed 1450 w. assume inner wall surface temperature of 1200°c and outer surface temperature of the insulation to be 15°c. calculate the thickness of insulation required.

Answers: 3

Answer

You know the right answer?

A company makes two kinds of leather belts A & B, Belt A is of high quality and belt B is of lo...

Questions