subject
Engineering, 12.02.2021 16:20 campilk5

Consider two reservoirs, A and B, connected in series with reservoir A situated upstream of reservoir B. The surface area of A is half of B. The area of B is 40 km2. Both reservoirs A and B are subject to a total rainfall of 50 cm and evaporation of 30 cm on an annual basis. To preserve the ecological environment in the riparian zone along the water course, reservoir A is required to release a constant flow of 0.1 m3/s to reservoir B, whereas reservoir B releases 0.3 m3/s to its downstream channel. At the present time, other than the in-stream flow requirement, there is no manmade structure withdrawing water from reservoir B. A small town of 50 000 is located near reservoir B. The per capita water consumption is 400 liters per day. The town is contemplating to use reservoir B as a water supply reservoir. a) Determine the annual water storage change of water (in cm) in each of the two reservoirs if water is to be delivered from reservoir B to satisfy the water consumption stipulated above.
b) To maintain the required in-stream flow requirement and per-capita consumption as stipulated above, for how long can this reservoir supply water to the town?
c) If the annual water storage change in reservoir B cannot be negative, how much of the percapita consumption has to be adjusted?

ansver
Answers: 1

Another question on Engineering

question
Engineering, 03.07.2019 15:10
Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.
Answers: 1
question
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
question
Engineering, 04.07.2019 18:20
Have a greater impact on maintenance productivity than any other support group. (clo5) a)-the top management b)-inventory and purchasing c)-sub-contracting d)-cmms
Answers: 2
question
Engineering, 04.07.2019 18:20
Describe one experiment in which the glass transition temperature and melting temperature of a totally amorphous thermoplastic material can be determined. show the relevant experimental results in a diagram which should be properly annotated with the two temperatures clearly marked. what is likely to happen to the curve in the diagram if the amorphous polymer is replaced by a thermosetting type?
Answers: 2
You know the right answer?
Consider two reservoirs, A and B, connected in series with reservoir A situated upstream of reservoi...
Questions
Questions on the website: 13722361