Engineering, 12.02.2021 14:00 peno211

A linear transformer couples a load consisting of a 360 O resistor in series with a 0.25 H
inductor to a sinusoidal voltage source, as
shown. The voltage source has an internal
impedance of 184 + /0 Cl and a maximum voltage of 245.20 V, and it is operating at 800 rad/s.
The transformer parameters are Ri = 100 fl,
Lt
= 0.5 H, R2 = 40 O, L2 = 0.125 H, and
k = 0.4. Calculate (a) the reflected impedance;
(b) the primary current; and (c) the secondary
current.

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

When at a point two solid phase changes to one solid phase on cooling then it is known as a) eutectoid point b) eutectic point c) peritectic point d) peritectoid point

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.

Answers: 3

Answer

You know the right answer?

A linear transformer couples a load consisting of a 360 O resistor in series with a 0.25 H
in...

Questions