Engineering, 12.02.2021 14:00 mmagee2020

Assume a 15 cm diameter wafer has a cost of 12, contains 84 dies, and has 0.020 defects/cm2 . Assume a 20 cm diameter wafer has a cost of 15, contains 100 dies, and has 0.031 defects/cm2. Find the yield for both wafers. Find the cost per die for both wafers. If the number of dies per wafer is increased by 10% and the defects per area unit increases by 15%, fi nd the die area and yield

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan

Answers: 3

Answer

Engineering, 04.07.2019 18:10

An air compression refrigeration system is to have an air pressure of 100 psia in the brine tank and an allowable air temperature increase of 60°f for standard vapor compression cycle temperatures of 77 f entering the expansion cylinder and 14 f entering the compression cylinder, calculate the coefficient of performance a. 2.5 b 3.3 c. 4.0 d. 5.0

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Atank with constant volume contains 2.27 kg of a mixture of water phases (liquid-vapor). in the initial state the temperature and the quality are 127 °c and 0.6, respectively. the mixture is heated until the temperature of 160 oc is reached. illustrate the process in a t-v diagram. then, determine (1) the mass of the vapor in kg at the initial state, (2) the final pressure in kpa.

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Aheavily insulated piston-cylinder device contains 0.02 m3 of steam at 300 kpa and 200 °c. 1.2 mpa. d this process. team is now compressed in a reversible manner to a pressure of etermine the entropy change and the work done on the steam during this process

Answers: 1

Answer

You know the right answer?

Assume a 15 cm diameter wafer has a cost of 12, contains 84 dies, and has 0.020 defects/cm2 . Assume...

Questions