Engineering, 12.02.2021 01:00 campbellkruger

Estimate the production of a tracked Caterpillar D5H with a straight blade using the production curves and correction table shown in page 19 and page 20 from . Excellent operator skill, loose stockpile material with a density of 2,000 lb/lcy, normal visibility, and 55 min/hr efficiency. The bulldozer will be pushing downhill on a 9% slope. Average distance 200 feet. a. What is the production rate in lcy/hr?
b. What would the production rate be with an average operator?
c. If you have a choice between an average operator making $15/hr and an excellent operator making $19/hr, which would be the cheapest alternative? Explain your answer

I put the slides you need

Estimate the production of a tracked Caterpillar D5H with a straight blade using the production cur

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Ifa component is made of two or more materials with different modulus of elasticity (e), it is called a composite member and we calculate the factor·n". mention the formula for calculating n". also, ifn> 1, explain what will happen to the 1. transformed.gi) ifn 1, what will happen to the material when transformed material when

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Describe one experiment in which the glass transition temperature and melting temperature of a totally amorphous thermoplastic material can be determined. show the relevant experimental results in a diagram which should be properly annotated with the two temperatures clearly marked. what is likely to happen to the curve in the diagram if the amorphous polymer is replaced by a thermosetting type?

Answers: 2

Answer

Engineering, 04.07.2019 19:10

The short distance from the objective lens to the object causes problems at high magnification. which of the following is the most serious? a. cleaning the object surface b. positioning the object c. reflection from the object surface. d. illumination of the object

Answers: 1

Answer

You know the right answer?

Estimate the production of a tracked Caterpillar D5H with a straight blade using the production curv...

Questions

Engineering, 30.03.2021 01:00

A power cycle operates between hot and cold reservoirs at 600 K and 300 K, respectively. At steady state the cycle develops a power output of 0.45 MW...