subject
Engineering, 08.02.2021 19:20 renegade2020

Assume that you have an incoming stream that contains 106 kg of wet gas (74.2 wt% methane, 15.6 wt% ethane, 5.5 wt% propane and the rest butane). The incoming stream is sent it to a separator (S1). Three streams leave the separator. Stream 2 is the top stream and contains only methane and ethane. Stream 2 contains 98% of the methane fed to the separator. Stream 3 is the middle stream and contains no butane. For every kg of methane in stream 3, there are 2.5 kg of ethane and 1.5 kg of propane. Stream 4 is the lower stream and contains only ethane, butane and propane. The mass flowrate of stream 4 is 10% of the incoming mass flowrate. Stream 4 is then sent to another separator (S2). Stream 5 leaves the top of S2 and contains 80% of the ethane and 50% of the propane entering S2 along with butane. Stream 6 leaves the bottom of S2 and contains all three components. The mass fraction of butane in stream 6 is 0.60. a. Draw and Label the diagram
b. Write equation(s) for the following statements:
1. For every kg of methane in stream 3, there are 2.5 kg of ethane and 1.5 kg of propane.
2. Stream 2 is the top stream and contains 98% of the methane fed to the separator.
3. The mass flowrate of stream 4 is 10% of the incoming mass flowrate.

c. Calculate the mass fraction of ethane in stream 2.
d. Calculate the mass of propane in stream 4.
e. Calculate the mass of butane in stream 5

ansver
Answers: 1

Another question on Engineering

question
Engineering, 03.07.2019 14:10
The y form of iron is known as: a) ferrite b) cementite c) perlite d) austenite
Answers: 3
question
Engineering, 04.07.2019 18:10
Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.
Answers: 3
question
Engineering, 04.07.2019 18:10
Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i.d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.
Answers: 3
question
Engineering, 04.07.2019 18:10
Atmospheric air has a temperature (dry bulb) of 80° f and a wet bulb temperature of 60° f when the barometric pressure is 14.696 psia. determine the specific humidity, grains/lb dry air. a. 11.4 c. 55.8 d. 22.5 b. 44.1
Answers: 1
You know the right answer?
Assume that you have an incoming stream that contains 106 kg of wet gas (74.2 wt% methane, 15.6 wt%...
Questions
question
Biology, 05.02.2021 05:30
question
Mathematics, 05.02.2021 05:30
Questions on the website: 13722361