Engineering, 08.02.2021 19:10 jjgurl60

The undisturbed soil at a given borrow pit is found to have the following properties: w = 15%; γ= 5 19.1 kN/m^3 ; Gs = 2.70. The soil from this borrow is to be used to construct a rolled fill having a finished volume of 38,500 m3 . The soil is excavated by means of a shovel and dumped onto trucks having a capacity of 4.80 m^3 each. When loaded to capacity, these trucks are found to contain, on the average, a net weight of soil and water equal to 72.7 kN. In the construction process, the trucks dump their load on the fill and the material is spread and broken up, after which a sprinkler adds water until the moisture content is equal to 18%. The soil and water are thoroughly mixed by a disc (or similar equipment) and then compacted until the dry unit weight is equal to 17.3 kN/m^3.
a. Assuming that each load is a full capacity load, how many truckloads are required to construct the fill?
b. What should be the volume of the pit that remains in the borrow area, after all the material required for the fill has been removed?
c. How many liters of water will have to be added per truck load, assuming that the moisture lost by evaporation during excavation, haulage, and handling is negligible?
d. If the fill should become saturated at some time subsequent to the construction and does not change volume appreciably, what will be its water content at saturation?

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

Amass of 1.5 kg of air at 120 kpa and 24°c is contained in a gas-tight, frictionless piston-cylinder device. the air is now compressed to a final pressure of 720 kpa. during the process, heat is transferred from the air such that the temperature inside the cylinder remains constant. calculate the boundary work input during this process.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux

Answers: 3

Answer

Engineering, 04.07.2019 19:10

10 kg of co2 is initially contained at 400 kpa and 300 k. the gas constant for carbon dioxide is 189 j/lkg k) and has a specific heat ratio, k, of 1.289. isentropic expansion then occurs until the pressure is 200 kpa. a) determine the initial volume of co2 in m. b) determine the final temperature in k. c) determine the work done by the system during the expansion kl.

Answers: 2

Answer

Engineering, 04.07.2019 19:10

Agas contained within a piston-cylinder assembly e end nation about same energy states, 1 and 2, where pi 10 bar, v undergoes two processes, a and b, between the sam 0.1 m3, ui-400 kj and p2 1 bar, v2 1.0 m2, u2 200 kj: process a: process from 1 to 2 during which the pressure- volume relation is pv constant process b: constant-volume process from state 1 to a pressure of 2 bar, followed by a linear pressure-volume process to +20 0 state 2 kinetic and potential energy effects can be ignored. for each of the processes a and b, (a) sketch the process on p-v coordinates, (b) evaluate the work, in kj, and (c) evaluate process the heat transfer, in kj

Answers: 2

Answer

You know the right answer?

The undisturbed soil at a given borrow pit is found to have the following properties: w = 15%; γ= 5...

Questions