Engineering, 02.02.2021 01:00 ily50

Based on the loads defined for this three dimensional (3-D) truss structure, complete the following for the redesign of outer truss sections: a) Determine the structural loads in truss members AD, AE, BE, CD, CE, and DE. b) Assuming that the truss members will all be constructed of 4130 alloy steel tubing, propose a cross-sectional geometry for each truss member that provides the following safety factors (FoS) - FoS of at least 3 against yielding, and - FoS of at least 1.5 against buckling. The cross-sectional geometry must be of standard stock sizes readily available from suppliers, such as OnlineMetals. c) Calculate the actual FoS for outer truss sections under the maximum defined loads based on your geometry selection(s). d) Estimate the material cost per truss sub-section, which contains the six truss members. e) Discuss the manufacturability of redesigned outer truss sections based on your geometry selection(s).

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Which of the following controllers anticipates the future from the slope of errors over time? a)-proportional b)-on/off c)-integral d)-derivative.

Answers: 2

Answer

Engineering, 04.07.2019 19:10

Tom is having a problem with his washing machine. he notices that the machine vibrates violently at a frequency of 1500 rpm due to an unknown rotating unbalance. the machine is mounted on 4 springs each having a stiffness of 10 kn/m. tom wishes to add an undamped vibration absorber attached by a spring under the machine the machine working frequency ranges between 800 rpm to 2000 rpm and its total mass while loaded is assumed to be 80 kg a) what should be the mass of the absorber added to the machine so that the natural frequency falls outside the working range? b) after a first trial of an absorber using a mass of 35 kg, the amplitude of the oscillation was found to be 10 cm. what is the value of the rotating unbalance? c) using me-3.5 kg.m, find the optimal absorber (by minimizing its mass). what would be the amplitude of the oscillation of the absorber?

Answers: 3

Answer

Engineering, 04.07.2019 19:10

Agas is compressed from vi 0.3 m, p 1 bar to of v2 0.1 m3, p2--3 bar. pressure and volume are related linearly during the process. for the gas, find the work, in kj.

Answers: 2

Answer

Engineering, 04.07.2019 19:20

Liquid flows at steady state at a rate of 2 lb/'s through a pump, which operates to raise the elevation of the liquid 100 ft from control volume inlet to exit. the liquid specific enthalpy at the inlet is 40.09 btu/lb and at the exit is 40.94 btub. the pump requires 3 btu/s of power to operate. if kinetic energy effects are negligible and gravitational acceleration is 32.174 tt/s, the heat transfer rate associated with this steady state process is most closely 1)-2,02 btu/s from the liquid to the surroundings 2)-3.98 btu/s from the surroundings to the liquid. 3)-4.96 btu/s from the surroundings to the liquid. 4)-1.04 btu/s from the liquid to the surroundings.

Answers: 2

Answer

You know the right answer?

Based on the loads defined for this three dimensional (3-D) truss structure, complete the following...

Questions