subject
Engineering, 01.02.2021 20:50 enrique3300

You are diving a car out in rural America and suddenly you get a flat tire. you pull off to the side of the road. you check your cell reception and dont have a single bar of signal (your cell phone won't work). you look around and there is no other cars or houses anywhere in sight and you do not remember the last time you saw a passing car or house. you are absolutely alone. the sun is setting and it is just starting to get dark. you get out and jack up the car, loosen the 4 nuts, take off the wheel with the flat tire. you grab the spare from the trunk and slide it onto the axle- you then look around for the 4 nuts and they are no where to he found. you search everywhere and cant find them. its gettint cold and dark. you look at the car, what can you do? all four of the nuts from the wheel have vanished snd are just gone. explain what you can do and why? remember, you cant call anyone because there is no reception, there is no one else on the road and you havent seen anyone in hours, its getting dark and cold, the 4 nuts from the wheel are gone, the car cannot drive safely with only 3 wheels

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Coiled springs ought to be very strong and stiff. si3n4 is a strong, stiff material. would you select this material for a spring? explain.
Answers: 2
question
Engineering, 04.07.2019 18:10
Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.
Answers: 3
question
Engineering, 04.07.2019 18:10
For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater
Answers: 3
question
Engineering, 04.07.2019 18:10
Which of the following refers to refers to how well the control system responds to sudden changes in the system. a)-transient regulation b)- distributed regulation c)-constant regulation d)-steady-state regulation
Answers: 1
You know the right answer?
You are diving a car out in rural America and suddenly you get a flat tire. you pull off to the side...
Questions
question
Mathematics, 14.11.2019 17:31
question
Chemistry, 14.11.2019 17:31
Questions on the website: 13722363