subject
Engineering, 29.01.2021 15:50 littleprinces

Multiple Choice Based the following, why would airports have pre-planned standby positions? Imagine an airport and all of the airplanes that must use the same runways. Sometimes the paved road or shortest distance to the crash site is occupied with other aircraft, so fire stations must run training scenarios on alternate routes. Most airports have created emergency roadways specifically for this purpose. They also have pre-planned standby positions where firefighters can wait for an aircraft that has initiated a call for help as a warning for a possible crash landing. a co-pilot calls in that smoke is filling the cabin as the plane approaches for landing O an airplane experiences a flat tire while taxiing to the gate a pilot reported she is hearing an alarm as the plane waits for takeoff O a small electrical fire has been detected on a plane as passengers are boarding

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 18:10
The flow rate of air through a through a pipe is 0.02 m5/s. a pitot static tube is placed in the flow. the radius of the pitot static tube is 1 mm. assuming the flow to be steady and the air to be at 300k, calculate the difference in total and static pressure if the diameter of the pipe is: (a) d 0.1 m d 0.05 m (c) d 0.01 m
Answers: 2
question
Engineering, 04.07.2019 18:20
Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um
Answers: 2
question
Engineering, 04.07.2019 18:20
An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.
Answers: 3
question
Engineering, 04.07.2019 19:10
The sum of the normal stresses does not change as the stress state rotates through an angle. a)-trune b)- false
Answers: 2
You know the right answer?
Multiple Choice Based the following, why would airports have pre-planned standby positions? Imagine...
Questions
question
English, 30.04.2021 23:50
question
Mathematics, 30.04.2021 23:50
question
Mathematics, 30.04.2021 23:50
Questions on the website: 13722362