Please help is due tonight
...
Answers: 3
Engineering, 04.07.2019 16:10
The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.
Answers: 1
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
Engineering, 04.07.2019 18:20
Have a greater impact on maintenance productivity than any other support group. (clo5) a)-the top management b)-inventory and purchasing c)-sub-contracting d)-cmms
Answers: 2
Engineering, 04.07.2019 18:20
Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um
Answers: 2
Social Studies, 25.09.2019 12:30
History, 25.09.2019 12:30
Social Studies, 25.09.2019 12:30
History, 25.09.2019 12:30
Mathematics, 25.09.2019 12:30
Mathematics, 25.09.2019 12:30
Mathematics, 25.09.2019 12:30
Mathematics, 25.09.2019 12:30
Mathematics, 25.09.2019 12:30
Computers and Technology, 25.09.2019 12:30
English, 25.09.2019 12:30
English, 25.09.2019 12:30