subject
Engineering, 21.01.2021 23:00 oliviagilpin8p6lk1i

Radioactive wastes are packed in a long, thin-walled cylindrical container. The wastes generate thermal energy nonuniformly according to the relation q=qω [1−(r/r o) 2 ], where q is the local rate of energy generation per unit volume, q o is a constant, and ro is the radius of the container. Steady-state conditions are maintained by submerging the container in a liquid that is at T[infinity] and provides at T[infinity] and provides uniform convection coefficient h. Obtain an expression for the total rate at which energy is generated in a unit length of the container. Use this result to obtain an expression for the temperature Ts of the container wall.

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Condition monitoring is a major component of. (clo4) a)- predictive maintenance. b)-preventive maintenance c)-proactive maintenance d)-reactive maintenance.
Answers: 1
question
Engineering, 05.07.2019 04:30
Technician a says that in a worm gear steering system, most excessive steering free play is usually found in the gearbox. technician b says that in a rack-and-pinion steering system, excessive free play can be found in the bushings. who is correct?
Answers: 2
question
Engineering, 06.07.2019 03:20
Areaction-bonded silicon nitride ceramic has a strength of 250 mpa and a fracture toughness of 3.4 mpa(m)^1/2, what is the largest-sized internal flaw that this material can support without fracturing? (use y -1 in the fracture-toughness equation.)
Answers: 3
question
Engineering, 06.07.2019 04:10
An array of m-50 thermoelectric modules is installed on the exhaust of a sports car. each module has an effective seebeck coefficient of sp of 0.143 5vk and an internal electrical resistance of r.-4 ? in addition, : (15 points each module is of width w 60mm and contains n=100 pairs of semiconducting pellets. each pellet hasan overall length of 2l-5mm and a cross-sectional area as 1.2 x 10'm and is characterized by a thermal conductivity of kpl2w rnk. the hot side of each module is exposed to exhaust gases at·p650c with hia4ow rrk while the osite side of each module is cooled by pressurized water at surface) and 156 °c (at the cool surface). 11s c with h: -500w/m'k. the modules are wired n series and the load resistance is r d=400ohm .the module surface temperatures, t, and ts are 183 "c (at the hot surface and 156c (at the cool surface) a)-draw a schematic of this scenario and label all parts. a. b. if the induced current, i, is 0.15 amps, what is the total power (pa) for one module? c. what is the total power harvest from the exhaust with all 50 modules?
Answers: 2
You know the right answer?
Radioactive wastes are packed in a long, thin-walled cylindrical container. The wastes generate ther...
Questions
Questions on the website: 13722367