Engineering, 19.01.2021 04:00 gymnastics255
11. What 2 ways would you specify a scale on the drawing, if it were drawn with a mechanical
engineer's scale of 1” = 1”
12. What 2 ways would you specify a scale on the drawing, if it were drawn with a mechanical
engineer's scale of 3” = 1”
13. What way would you specify a scale on the drawing, if it were drawn with a metric engineer's
scale of half size
Answers: 1
Engineering, 03.07.2019 14:10
Line joining liquid phase with liquid and solid phase mixture is known as: a) liquidus b) solidus c) tie line d) none of the mentioned
Answers: 2
Engineering, 03.07.2019 19:30
When using the ohmmeter function of a digital multimeter, the leads are placed in what position relative to the component being tested? a. parallel b. control c. series d. line
Answers: 3
Engineering, 04.07.2019 18:10
Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2
Answers: 3
Engineering, 04.07.2019 18:10
Thermal stresses are developed in a metal when its a) initial temperature is changed b) final temperature is changed c) density is changed d) thermal deformation is prevented e) expansion is prevented f) contraction is prevented
Answers: 2
11. What 2 ways would you specify a scale on the drawing, if it were drawn with a mechanical
engine...
History, 08.12.2019 04:31
Mathematics, 08.12.2019 04:31
Mathematics, 08.12.2019 04:31
English, 08.12.2019 04:31
English, 08.12.2019 04:31
English, 08.12.2019 04:31
History, 08.12.2019 04:31
History, 08.12.2019 04:31
Mathematics, 08.12.2019 04:31
Mathematics, 08.12.2019 04:31
English, 08.12.2019 04:31