Engineering, 18.01.2021 14:00 gl648809

A shell-and-tube heat exchanger is to heat 10,000 kg/hr of water from 16 oC to 84 oC by hot engine oil flowing through the shell. The oil makes a single shell pass, entering at 160 oC and leaving at 94 oC, with an average heat transfer coefficient of 400 W/m2K. The water flows through 11 brass tubes of 22.9 mm inside diameter and 25.4 mm outside diameter, with each tube making 4 passes through the shell. Required:
a. Assuming fully developed flow determine the required tube length per pass.
b. For the tube length found in part (1), plot the effectiveness, fluid outlet temperatures, and water-side convection coefficient as a function of water flow rate for 5000 <=15,000 kg/h, with all other conditions remaining the same.

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Burgers vector is generally parallel to the dislocation line. a)-true b)-false

Answers: 2

Answer

Engineering, 04.07.2019 19:10

Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.

Answers: 2

Answer

Engineering, 04.07.2019 19:20

Brief discuss how the presence of dislocations in crystal structures can be an advantage and a disadvantage to engineer and designers.

Answers: 3

Answer

Engineering, 04.07.2019 19:20

Air at a pressure of 1atm and a temperature of 40 c is in parallel flow over the top surface of a flat plate that is heated to a uniform temperature of 120 c. the plate has a length of 0.40m (in the flow direction) and a width of 0.15m. the reynolds number based on the plate length is 50, 000. what is the rate of heat transfer from the plate to the air? if the free stream velocity of the air is doubled and the pressure is increased to 10 atm what is the rate of heat transfer?

Answers: 2

Answer

You know the right answer?

A shell-and-tube heat exchanger is to heat 10,000 kg/hr of water from 16 oC to 84 oC by hot engine o...

Questions