Engineering, 14.01.2021 15:00 dontcareanyonemo

Equilateral triangular sewer, 1.5 m on each side, constructed of concrete, used to drain at a flow rate of 1000 kg / m 5, with the effluent density of 1100 kg / m and viscosity of 1.25 cP, length 10. km before entering the center. Calculate 1.1 The area of contact with the sewage of the pipe (Perimeter of pipe, P) is equal to how many meters?
1.2 The cross-sectional area of the sewer. (Goss-sectional are, A) is how many square meters?
1.3 What is the hydraulic radius, R. Since the in-pipe flow (h) is equal to the water meter when calculated with the Hazen Williams Formula, it has a Hazen-Williams constant of 110 1.6 What is the system pressure drop in kPa 1.7 The power of the pump at How many watts must be compensated for the system when the pump efficiency is 0.85 1.8 Reynolds number of particles?

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Machinery that is a key part of the process and without which the plant or process cannot function is classifed as: (clo4) a)-critical machinery b)-essential machinery c)-general purpose machinery d)-none of the specified options.

Answers: 1

Answer

Engineering, 04.07.2019 19:10

Agas contained within a piston-cylinder assembly e end nation about same energy states, 1 and 2, where pi 10 bar, v undergoes two processes, a and b, between the sam 0.1 m3, ui-400 kj and p2 1 bar, v2 1.0 m2, u2 200 kj: process a: process from 1 to 2 during which the pressure- volume relation is pv constant process b: constant-volume process from state 1 to a pressure of 2 bar, followed by a linear pressure-volume process to +20 0 state 2 kinetic and potential energy effects can be ignored. for each of the processes a and b, (a) sketch the process on p-v coordinates, (b) evaluate the work, in kj, and (c) evaluate process the heat transfer, in kj

Answers: 2

Answer

Engineering, 04.07.2019 19:20

In the winter, in order to keep the classroom steadily at 68 f before 10 pm, heating with an average rate of 42,000 btu/hr is provided. assume the outdoor temperature maintains at 32°f, determine the electrical power (kw) required to (a) operate a reversible heat pump (b) operate a real heat pump with a cop (7) of 4.5 and (c) operate an electrical-resistance heater.

Answers: 3

Answer

You know the right answer?

Equilateral triangular sewer, 1.5 m on each side, constructed of concrete, used to drain at a flow r...

Questions