Engineering, 12.01.2021 17:30 ctyrector

The steel bar with the geometry has an axial fluctuating load applied from -5000 lbf to 12000 lbf. The bar has a hole with a 0.25 inch diameter, is 0.25 inches thick, a fillet radii of 0.175 inches, and a notch sensitivity factor q = 0.95. The fully adjusted endurance limit of the bar is 40 ksi, the bar has an ultimate strength of 185 ksi, and a fatigue strength fraction f = 0.78. Using the Goodman criteria, determine the most conservative N to design to, where N is the life of the bar in terms of cycles to failure. a. Less than 1 cycle
b. 1 to 5 cycles
c. 17000 to 29000 cycles
d. 40000 to 60000 cycles
e. 63000 to 80000 cycles
f. 5 to 6 million cycles
g. Infinite life

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Vibration monitoring this technique uses the noise or vibration created by mechanical equipment and in seme cases by plant systems to detemine their actual condtion. a)- true b)- false

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Air flows over a heated plate àt a velocity of 50m/s. the local skin factor coefficient at a point on a plate is 0.004. estimate the local heat transfer coefficient at this point.the following property data for air are given: density = 0.88kg/m3 , viscosity 2.286 x 10 ^-5 kgm/s , k = 0.035w/mk ,cp = 1.001kj/kgk. use colburn reynolds analogy.

Answers: 1

Answer

Engineering, 06.07.2019 02:30

An electric motor is used to drive a power press which makes steel turning moment diagrams 323 pressings from a metal sheet. the motor runs at a mean speed of 50 rev/s. the torque required is 10.0nm for 0.2s, followed by 1.0nm for0.3 s with this sequence then being repeated. what is the minimum power required of the motor and the moment of incrtia required for the t1ywhcel if the speed fluctuations are to be restricted to 1.5%?

Answers: 3

Answer

You know the right answer?

The steel bar with the geometry has an axial fluctuating load applied from -5000 lbf to 12000 lbf. T...

Questions