Engineering, 07.01.2021 21:10 xbeatdroperzx
Select three ways that fluid power systems are becoming more efficient.
implementation of microstructures
decreased fuel power
increased carbon emissions
reduction of valves
installation of regenerative braking
Answers: 3
Engineering, 04.07.2019 18:10
Machinery that is a key part of the process and without which the plant or process cannot function is classifed as: (clo4) a)-critical machinery b)-essential machinery c)-general purpose machinery d)-none of the specified options.
Answers: 1
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
Engineering, 04.07.2019 18:20
The characteristic roots of a dynamic system are: 1.7920 1.8160 i, -1.7920 1.8160 i, -0.4160 what is the order of this system? what are the settling time and damping ratio of the system?
Answers: 3
Engineering, 04.07.2019 18:20
Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um
Answers: 2
Select three ways that fluid power systems are becoming more efficient.
implementation of microstru...
Spanish, 20.09.2020 08:01
Mathematics, 20.09.2020 08:01
Mathematics, 20.09.2020 08:01
Biology, 20.09.2020 08:01
Mathematics, 20.09.2020 08:01
Chemistry, 20.09.2020 08:01
Mathematics, 20.09.2020 08:01
English, 20.09.2020 08:01
Mathematics, 20.09.2020 08:01
Mathematics, 20.09.2020 08:01
English, 20.09.2020 08:01
Mathematics, 20.09.2020 08:01