subject
Engineering, 02.01.2021 20:00 Nismo3501037

Q1The motor M of the hoist shown in Fig. 14-16a lifts the 75-lb crate C so that the acceleration of point P is 4 ft/S2. Determine the power that must be supplied to the motor at the instant P has a velocity of 2 ft/s. Neglect the mass of the pulley and cable and take E = 0.85

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
question
Engineering, 04.07.2019 18:20
How much power could a wind turbine produce if it had the following specifications? cp = 0.45 -d=1.2kg/m3 d=50m v 5m/s
Answers: 2
question
Engineering, 04.07.2019 19:10
For a process taking place in a closed system containing gas, the volume and pressure relationship is pvi-constant. -1.5 bar, the process starts with initial conditions, pi = =0.03 m3 and ends with final volume, v2-0.05 m3 determine the work done by the gas.
Answers: 2
question
Engineering, 04.07.2019 19:20
List 3 options on how to reduce knocking problens during engine process,
Answers: 2
You know the right answer?
Q1The motor M of the hoist shown in Fig. 14-16a lifts the 75-lb crate C so that the acceleration of...
Questions
Questions on the website: 13722367