A PLL is set up so that its VCO free-runs at 8.9 MHz. The VCO does not change frequency unless its input is within plus or minus 75 kHz of 8.9 MHz. After it does lock, the input frequency can be adjusted within plus or minus 120 kHz of 8.9 MHz without having the PLL start to free-run again. The tracking range of the PLL is:. a) 75 kHz.
b) 120 kHz.
c) 150 kHz.
d) 240 kHz.

The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.

An air conditioning system consist of a 5 cm diameter pipe, operating at a pressure of 200 kpa. the air initially enters the pipe at 15°c with a velocity of 20 m/s and relative humidity of 80%. if the heat supply throughout the process is 960 w, determine the relative humidity and the temperature at the outlet

Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.