subject
Engineering, 21.12.2020 14:00 catherinesquitieri

Springfield University has hired you to develop a web-based system to handle enrollment. Here are Solution Domain Scenarios that describe one aspect of how the system will be
used:
Dean Peterson, the convenor for Introduction to Programming, wants to see which students
are enrolled in his unit. He browses to the Enrolment System site and logs in. As he is a
staff member, it shows him a list of all the units offered by the university. He scrolls down
to ‘Introduction to Programming’ and clicks on the title, which takes him to an information
page for the unit. Dean then clicks the ‘Current Enrollment’ list and the system presents
him with a list of all the students currently enrolled in Introduction to Programming. Dean
scrolls down to the student Gary Benjamin and clicks his name. The system then shows him
Gary’s details.
Leopold is the convenor for Web Development. He logs into the Enrolment System,
browses the list of units offered and selects ‘Introduction to Programming’. The system
displays an error message “You are not a convener for this unit”.
Write a single Use Case that captures these scenarios. Include use case title, actor, scenario,
pre-condition, post-condition and exception.

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 18:20
A3-mm-thick panel of aluminum alloy (k 177 w/m-k, c 875 j/kg-k and ? = 2770 kg/m) is finished on both sides with an epoxy coating that must be cured at or above t,-150°c for at least 5 min. the production line for the curing operation involves two steps: (1) heating in a large oven with air at ts,0-175°c and a convection coefficient of h, 40 w/m2. k, and (2) cooling in a large chamber with air at 25°c and a con- vection coefficient of he 10 w/m2.k. the heating portion of the process is conducted over a time interval te which exceeds the ime required to reach 150°c by 5 min (h = r + 300 s). the coating has an emissivity of ? = 0.8, and the temperatures of the oven and chamber walls are 175 and 25°c, respectively. if the panel is placed in the oven at an initial temperature of 25°c and removed from the chamber at a safe-to-touch tempera ture of 37°c, what is the total elapsed time for the two-step curing operation?
Answers: 3
question
Engineering, 06.07.2019 02:30
A12 mm diameter shaft runs in a plain cylindrical bush 30 mm long that is located in an 18 mm diameter hole in a housing. the shaft-inner bush fit is h8 f and the outer bush-housing fit is h7-p6. make a fully cimensioned sketch of the bush with tolerances. find the maximum and minimum clearance or interference for both fits on the inner and outer diameters of the bush
Answers: 3
question
Engineering, 06.07.2019 03:20
Write a technical essay (maximum two pages) about stress concentration. and paste from the textbook. instead, read updated material about this phenomenon and provide a technical evaluation of the different techniques to avoid/reduce such phenomenon. consider in your analysis cutting-edge computational techniques such as fea to study and analyze stress concentrations.
Answers: 2
question
Engineering, 06.07.2019 04:10
An inventor claims to have developed a reversed heat engine (ie. a heat pump) which is able to deliver 10 kj heat into the room at 20°c from outside ambient temperature of -10°c by consuming only 2 kj electricity in winter. this claim is a)-impossible b)-possible only if the heat pump is ideal c)-practically possible d)-unable to be assessed as it depends on the working fluid used in the heat pump.
Answers: 2
You know the right answer?
Springfield University has hired you to develop a web-based system to handle enrollment. Here are S...
Questions
Questions on the website: 13722363