subject
Engineering, 19.12.2020 01:00 kennakenken3

PINNACLE Question 29 of 35
Using the directions below, create a drawing and identify the resulting image.
1. In the middle of the page, draw two vertical lines an inch long, an inch apart, and
that are parallel to each other.
2. About a half inch below the lines, draw a half-inch horizontal line that is centered
between the lines
3. Draw a line from the bottom of the left vertical line and connect it to the left end of
the horizontal line
4. Draw a line from the bottom of the right vertical line and connect it to the right end
of the horizontal line
5. From the top of the left vertical line draw a large arc and connect it to the top of
the right vertical line.
Which of the following does your image most resemble?
O a light bulb
a wheel
a pot
a railroad crossing sign
e

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
An ideal otto cycle with air as the working fluid has a compression ratio of 8. the minimum and maximum temperatures in the cycle are 300 k and 1340 k. use constant specific heats at room temperature to determine (a) the amount of heat transferred to the air during the heat- addition kj/kg, (b) the thermal efficiency, and (c) the thermal efficiency of a carnot cycle ope limits. process, in rating between the same temperature
Answers: 2
question
Engineering, 04.07.2019 18:10
Which of the following controllers anticipates the future from the slope of errors over time? a)-proportional b)-on/off c)-integral d)-derivative.
Answers: 2
question
Engineering, 04.07.2019 19:20
Determine (a) the maximum thermal efficiency of reversible power cycles operating between a hot reservoir at 1000°c and a cold reservoir at 200°c and (b) the maximum cops for reversible refrigeration and heat pump cycies, respectively, between 28°c and 14°c.
Answers: 1
question
Engineering, 06.07.2019 04:10
Along steel shaft of 10 cm diameter is austenised at 870°c and then quenched in a liquid at 30oc. the average surface heat transfer coefficient is 2000 w/m2. °c. the relevant thermophysical properties of the shaft are: p=7800 kg/m", k=20 w/mk, cp=0.46 kj/kg.k calculate: a)-the time required for the center temperature to drop to 200°c. b)-the temperature at half-radius at that moment. c)-the amount of heat that had been transferred to the liquid by that time per meter length of the shaft
Answers: 1
You know the right answer?
PINNACLE Question 29 of 35
Using the directions below, create a drawing and identify the resu...
Questions
question
Mathematics, 11.02.2021 21:10
Questions on the website: 13722359