Engineering, 18.12.2020 21:50 marilyn73471
Design and analyze cam profiles. Using MATLAB code,
1. Draw the displacement and velocity diagrams for the complete motion cycle, clearly demarcating the different regions of motion
2. Draw the pitch curve showing the Base circle as well.
3. Keep the base circle radius fixed and change the ‘lift’ value by 30% in the increments of 10%. Study the effect of this on the pitch curve compared to the original curve got in (2) above.
Speed of the cam can be assumed if necessary.
Note:
Follower type: Knife edge
Event sequence: Dwell-Rise-Dwell-Fall
Event: Rise from 120 to 210 and Fall from 270 to 360
Motion type: Parabolic
Rb(mm):65, Rf(mm):16, Lift(mm):39
Answers: 3
Another question on Engineering
Engineering, 03.07.2019 14:10
If the thermal strain developed in polyimide film during deposition is given as 0.0044. assume room temperature is kept at 17.3 c, and thermal coefficient of expansion for the film and the substrate are 54 x 10^-6c^-1 and 3.3 x 10^-6c^-1respectively. calculate the deposition temperature.
Answers: 3
Engineering, 04.07.2019 18:10
Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10
Answers: 1
Engineering, 04.07.2019 18:20
Find the kinematic pressure of 160kpa. for air, r-287 j/ kg k. and hair al viscosity of air at a temperature of 50°c and an absolute (10 points) (b) find the dynamic viscosity of air at 110 °c. sutherland constant for air is 111k
Answers: 3
Engineering, 04.07.2019 19:10
The air in an automobile tire with a volume of 0.015 m3 is at 32°c and 140 kpa gage. determine the amount of air that must be added to raise the pressure to the recommended value of 206 kpa gage. assume the atmospheric pressure to be 128 kpa and the temperature and the volume to remain constant.[r-0.287 kj/kgk]
Answers: 3
You know the right answer?
Design and analyze cam profiles. Using MATLAB code,
1. Draw the displacement and velocity diagrams...
Questions
Biology, 22.04.2020 01:47
Mathematics, 22.04.2020 01:47
English, 22.04.2020 01:47
History, 22.04.2020 01:48
Mathematics, 22.04.2020 01:48
