subject
Engineering, 08.12.2020 19:10 andaws21

(True/False) Unix is written in the C language. *
True
O False

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 18:20
Along 8-cm diameter steam pipe whose external surface temperature is 900c connects two buildings. the pipe is exposed to ambient air at 70c with a wind speed of 50 km/hr blowing across the pipe. determine the heat loss from the pipe per unit length. (b) air at 500c enters a section of a rectangular duct (15 cm x 20 cm) at an average velocity of 7 m/s. if the walls of the duct are maintained at 100c. a) the length of the tube for an exit temperature of the air to be 40 0c. b)the rate of heat transfer from the air. c) the fan power needed to overcome the pressure drop in this section of the duct.
Answers: 1
question
Engineering, 06.07.2019 03:30
Acubic shaped box has a side length of 1.0 ft and a mass of 10 lbm is sliding on a frictionless horizontal surface towards a 30 upward incline. the horizontal velocity of the box is 20 ft/s. determine how far up the incline the box will travel (report center of mass distance along the inclined surface, not vertical distance)
Answers: 1
question
Engineering, 06.07.2019 04:10
An array of m-50 thermoelectric modules is installed on the exhaust of a sports car. each module has an effective seebeck coefficient of sp of 0.143 5vk and an internal electrical resistance of r.-4 ? in addition, : (15 points each module is of width w 60mm and contains n=100 pairs of semiconducting pellets. each pellet hasan overall length of 2l-5mm and a cross-sectional area as 1.2 x 10'm and is characterized by a thermal conductivity of kpl2w rnk. the hot side of each module is exposed to exhaust gases at·p650c with hia4ow rrk while the osite side of each module is cooled by pressurized water at surface) and 156 °c (at the cool surface). 11s c with h: -500w/m'k. the modules are wired n series and the load resistance is r d=400ohm .the module surface temperatures, t, and ts are 183 "c (at the hot surface and 156c (at the cool surface) a)-draw a schematic of this scenario and label all parts. a. b. if the induced current, i, is 0.15 amps, what is the total power (pa) for one module? c. what is the total power harvest from the exhaust with all 50 modules?
Answers: 2
question
Engineering, 06.07.2019 04:20
In modern manufacturing, which types of metal chips would be undesirable and why ? ?
Answers: 3
You know the right answer?
(True/False) Unix is written in the C language. *
True
O False...
Questions
question
Mathematics, 27.09.2019 08:30
question
English, 27.09.2019 08:30
question
Computers and Technology, 27.09.2019 08:30
question
Mathematics, 27.09.2019 08:30
Questions on the website: 13722367