How are most abrasives held in place on the disk sander?
O A. adhesives
O B. Screws
OC...
Engineering, 04.12.2020 18:20 lydialinton23
How are most abrasives held in place on the disk sander?
O A. adhesives
O B. Screws
OC springs
O D. tape
Answers: 2
Another question on Engineering
Engineering, 04.07.2019 18:10
Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.
Answers: 2
Engineering, 04.07.2019 18:10
Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?
Answers: 3
Engineering, 04.07.2019 18:10
Journeyman training is usually related (clo2) a)-to specific tasks b)-to cost analysis of maintenance task c)-to control process to ensure quality d)-to installation of machinery
Answers: 2
Engineering, 04.07.2019 18:20
Find the kinematic pressure of 160kpa. for air, r-287 j/ kg k. and hair al viscosity of air at a temperature of 50°c and an absolute (10 points) (b) find the dynamic viscosity of air at 110 °c. sutherland constant for air is 111k
Answers: 3
You know the right answer?
Questions
Mathematics, 25.05.2021 04:30
History, 25.05.2021 04:30
Mathematics, 25.05.2021 04:30
Mathematics, 25.05.2021 04:30
Mathematics, 25.05.2021 04:30
Mathematics, 25.05.2021 04:30
Mathematics, 25.05.2021 04:40
Mathematics, 25.05.2021 04:40
Chemistry, 25.05.2021 04:40
