Engineering, 04.12.2020 01:00 demetriascott20
All of these are true about GMA (MIG) welding EXCEPT that:
O both the base metal and electrode are melted.
O shielding gas protects the well, tiom contamination.
O heat is produced using a short electric arc.
the welding gun liner regulates the shielding gas.
Answers: 2
Another question on Engineering
Engineering, 04.07.2019 18:10
The mass flow rate of the fluid remains constant in all steady flow process. a)- true b)- false
Answers: 1
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
Engineering, 04.07.2019 18:10
Condition monitoring is a major component of. (clo4) a)- predictive maintenance. b)-preventive maintenance c)-proactive maintenance d)-reactive maintenance.
Answers: 1
Engineering, 04.07.2019 18:10
Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan
Answers: 3
You know the right answer?
All of these are true about GMA (MIG) welding EXCEPT that:
O both the base metal and electrode are...
Questions
English, 23.05.2020 02:01
Biology, 23.05.2020 02:01
English, 23.05.2020 02:01
English, 23.05.2020 02:01
Biology, 23.05.2020 02:01
English, 23.05.2020 02:01
Mathematics, 23.05.2020 02:01
Mathematics, 23.05.2020 02:01
Spanish, 23.05.2020 02:01
Health, 23.05.2020 02:01
English, 23.05.2020 02:01
Physics, 23.05.2020 02:01
Mathematics, 23.05.2020 02:01
